Our systems have detected that you appear to be viewing this site from United States.
We are geared up to offer you a far better service from our USA site.

You can choose to Continue to USA site or Stay on AUS site.

CB500F/X & CBR500R Frame Covers

To use the abba Superbike stand or abba Sky Lift on the 2016-On Honda CB500F, 2019-On Honda CB500X & CBR500R models, two plastic frame covers need to be replaced to use the product correctly. This is a simple task that only has to be done once but please read fully below to understand the procedure before purchasing any abba product for this bike.

What is the issue?

The swing arm pivot (where our products connect to the bike) is not accessible on this bike as Honda have now covered the pivot bolt recesses with a plastic trim cover (this was not the case on the pre 2016 models)

Removing this cover every time you want to use your abba lift or stand would be very inconvenient as it is partly held in place by the foot rest hanger bolts, meaning the foot rests would need to be removed to release the cover every time.

The picture (right) shows the standard cover fitted to the CB500F/X & CBR500R

 

The Solution:

When you purchase the Sky Lift, Superbike stand or just the fitting kit for this bike you will receive the necessary abba fittings to adapt your stand to fit this bike along with two genuine Honda modified side covers.

The two covers we supply are genuine parts purchased from Honda, we then make a simple and clean modification to remove the embellishment which restricts access to the swing arm pivot.

Modified covers shown (right)

  • Problem solved!

Fitting the supplied modified covers:

Removing your bikes standard covers and replacing them with the modified versions is a simple task that will only take around 15 mins to complete, remember you only have to do this once! If at any point you wish to return the bike back to complete standard (maybe to sell the bike) your original covers can easily be re fitted.

To remove either side panel simply loosen the two 8mm hex bolts and pop the cover out. Replace with the supplied modified cover, push into position, re fit and tighten the two 8mm hex bolts.

 

 

 

 

 

 

Original cover being removed. (Left hand side of bike) -

 

 

   Modified cover re fitted -

 

 

 

 

 

Once the modified covers have been fitted the Superbike stand or Sky Lift can be fitted in the normal way. (refer to product video and instructions for more information on this).

 

                                                       Superbike stand fitted pictures:  (this is the same for the CBR500R & CB500F/X)

  • Please note this kit is not suitable for the 2017-2018 CB500X

If you require any further information on the this please do not hesitate to contact us.